Support
How can we help you?
If unable to find help in our Support section, please contact your local Mastercam reseller before contacting CIMCO directly.
Video tutorials
Tutorial 1
Width and Rectangle Inside/Outside(16:32)
How to set a Work Offset using the Renishaw Inspection Plus cycles:
  • Width Inside and Outside in the X- and Y-axis
  • Rectangle Inside and Outside in both the X- and Y-axis
Tutorial 2
Diameter Inside/Outside 4-points(8:49)
How to set a Work Offset using the Renishaw Inspection Plus cycles:
  • Diameter Inside 4-Points
  • Diameter Outside 4-Points
Tutorial 3
Diameter Inside/Outside 3-points(8:26)
How to set a Work Offset using the Renishaw Inspection Plus cycles:
  • Diameter Inside 3-Points
  • Diameter Outside 3-Points
Tutorial 4
Point One Axis(8:26)
How to set a Work Offset using the Renishaw Inspection Plus cycle:
  • Point One Axis
Tutorial 5
Corner Inside and Outside(8:26)
How to set a Work Offset using the Renishaw Inspection Plus cycles:
  • Corner Inside
  • Corner Outside
Tutorial 6
Angled Width Inside and Outside(8:29)
How to set a Work Offset using the Renishaw Inspection Plus cycles:
  • Angled Width Inside
  • Angled Width Outside
Tutorial 7
Point at Angle(4:54)
How to set a Work Offset using the Renishaw Inspection Plus cycle:
  • Point at Angle
Tutorial 8
How to install(3:32)
In this video we show you the steps to download, install and configure CIMCO Probing inside Mastercam.
New add-on for Mastercam

Brings the world’s fastest Solid Simulation to Mastercam®